STR-60-100V-BLDC-MDK-GEVK：1kW、60-100V 电机开发板

STR-60-100V-BLDC-MDK-GEVK: 1kW, 60-100V Motor Development Board

设计简介

The STR-60-100V-BLDC-MDK-GEVK is a comprehensive motor development board and a reference design for drive low voltage 3-phase BLDC motors. The power board consists of 6 NTMFS7D5N15MC MOSFETs for the inverter stage and NCP1034 PWM synchronous buck controller for power conversion. The 3-phase power board is rated for a maximum of 100V DC and consists of all necessary system blocks for a BLDC motor driver. As part of the motor development kit, the power board is compatible with the power Universal controller board enabling high-end control strategies and AI capabilities for industrial motor control. The complete kit is Strata enabled and the graphical user interface can be used to set control parameters for the motor drive.

The STR-60-100V-BLDC-MDK-GEVK comprises of the 1kW, 100V power board, hardware adapter for the UCB, and the Universal Controller Board (UCB)

For the Power board only, visit STR-60-100V-BLDC-MDK-GEVB

Features and Applications

Features

Power board for Motor Development Kit (MDK)
Compatible with the Universal Controller Board (UCB) FPGA/ARM
Fully compatible with Xilinx® development tools for Zynq®-7000
Strata Enabled
Downloadable Trapezoidal control use cases for the UCB
VIN: 60V - 100V DC
Compatible with three-phase BLDC motors
Over current protection (OCP), Over voltage protection (OVP)
Plug-in connector interface for MCU cards (Arduino DUE footprint)
Sensored Trapezoidal control strategy implemented
Strata enabled and available for a quick-start evaluation
Xilinx® development tools and environments are available for the MDK, such as Vitis and Vivado to program the FPGA

Applications

Autonomous Mobile Robots / Automated Guided Vehicles
Industrial drives and Robots
Fans, Pumps, and Compressors

参考设计下载

！注意：请使用浏览器自带下载，迅雷等下载软件可能无法下载到有效资源。

相关器件

器件	类型	描述	数据手册
2N7002L	MOSFETs	N-Channel Small Signal MOSFET 60V 115mA 7.5 Ω	点击下载
BAT54H	Schottky Diodes & Schottky Rectifiers	200 mA, 30 V, Schottky Diode	点击下载
FAN5331	Converters	Adjustable, 1.6MHz Boost Regulator with 20V Integrated FET Switch	点击下载
FDMC86244	MOSFETs	N-Channel Power Trench^® MOSFET 150V, 9.4a, 134mΩ	点击下载
FPF3380	Protected Power Switches	Low Rdson Over-Voltage Protection Load Switch	点击下载
MBR130	Schottky Diodes & Schottky Rectifiers	1.0 A, 30 V, Schottky Power Rectifier, Surface Mount	点击下载
MC74VHC1G03	Logic Gates	Single 2-Input NOR Gate, Open Drain	点击下载
NCP1034	Controllers	100 V Synchronous Buck Controller	点击下载
NCP1729	Charge Pumps	Charge Pump, Switched Capacitor Voltage Inverter with Shutdown, 50 mA, 35 kHz	点击下载
NCP705	Linear Regulators (LDO)	LDO Regulator, 500 mA, Ultra-Low Iq, High PSRR, Ultra-Low Noise	点击下载
NCP711	Linear Regulators (LDO)	LDO Regulator, 100 mA, 18 V, 1 uA IQ, with PG	点击下载
NCP781	Linear Regulators (LDO)	Linear Voltage Regulator, 100 mA, 150 V, High PSRR	点击下载
NCP81075	Gate Drivers	High Side and Low Side Gate Driver, High-Frequency, 180 V, 4A capability	点击下载
NCS20061	Operational Amplifiers (Op Amps)	Operational Amplifier, 5.5V Rail-to-Rail Input and Output, 3 MHz, Single	点击下载
NCS20062	Operational Amplifiers (Op Amps)	Operational Amplifier, 5.5V Rail-to-Rail Input and Output, 3 MHz, Dual	点击下载
NCS20166	Operational Amplifiers (Op Amps)	Precision Operational Amplifier, Low Offset, 10 MHz, Rail-to-Rail Input / Output	点击下载
NCS21911	Operational Amplifiers (Op Amps)	Precision Operational Amplifier, 2 MHz Bandwidth, Low Noise, Zero-Drift, 25 µV Offset	点击下载
NCS2252	Comparators	Comparator, High Speed, 50 ns, Low Voltage, Rail-to-Rail, Open Drain	点击下载
NCT375	Temperature Sensors	Digital Temperature Sensor with 2‐wire Interface and SMBus Time-Out	点击下载
NSR05F30NX	Schottky Diodes & Schottky Rectifiers	500 mA, 30 V, Schottky Diode	点击下载
NTMFS7D5N15MC	MOSFETs	N-Channel Shielded Gate PowerTrench® MOSFET 150V, 95.6A, 7.9mΩ	点击下载
S115FA	Schottky Diodes & Schottky Rectifiers	1.0 A, 150 V, Surface Mount Schottky Barrier Rectifiers	点击下载

群聊设计，与管理员及时沟通

欢迎加入EEWorld参考设计群，也许能碰到搞同一个设计的小伙伴，群聊设计经验和难点。入群方式：微信搜索“helloeeworld”或者扫描二维码，备注：参考设计，即可被拉入群。另外，如您在下载此设计遇到问题，也可以微信添加“helloeeworld”及时沟通。

网友评论

点击登录后，参与评论

版权和使用说明

热门项目

热门活动更多

下载中心更多

查找数据手册?

EEWorld Datasheet 技术支持

大学堂更多

论坛推荐更多

更新时间2024-11-21 12:15:19

1kw加热棒， 220v供电，如何实现加热棒300-1kw可调。
1）目前有一个1kw的加热棒，需要可调功率300w-1000w，步进50w。请教一下各位前辈，有没有好的解决方案。
仅用100W功率就能对1kw设备进行老化测试的传输线
仅用100W功率就能对1kw设备进行老化测试的传输线一台13.56MHz ISM（工业、科学和医疗）频段射频测量设备要求进行50小时1kw 设备需要同时加上等效于1kw的射频电压和射频电流，而手里唯一可用的射频信号
100套平头哥RISC-V低功耗RVB2601开发板等你来，还有投影仪等好礼~
2022年新征程启动，EEWorld社区和平头哥邀请您共建RISC-V生态，参与RVB2601开源创意应用创意征集活动。共100套、价值390元RVB2601等你来领。机会多多，速来速来。
项目要做一个DC-DC车载电源，输入300—1000V，输出0—30V，功率大概2KW, 目前考虑...
项目要做一个DC-DC车载电源，输入300 1000V，输出0 30V，功率大概2KW, 目前考虑到效率问题，想用两级级联的结构，前级和后级用什么拓扑比较好？
宇宙飞船用1kW充电器方案讨论
最近要接手一个项目，用在航空领域，太阳能光伏电池给锂电池充电，太阳能电池板电压28V，电池充电截止电压也是28V，最大输出电流35A，也即输出功率约为1kW，效率要求大于90%，不知道用什么拓扑更为合适
这种DC60V 100AH 电池组逆变成AC220V15A 同时带太阳能MPPT功率跟踪的储能电源哪...
这种DC60V 100AH 电池组逆变成AC220V15A 同时带太阳能MPPT功率跟踪的储能电源哪个有设计过？或者有方案的？可以供PCBA，需要和客户对接，有些需要调整参数。

Datasheet 更多

精选电路图更多

STR-60-100V-BLDC-MDK-GEVK：1kW、60-100V 电机开发板

STR-60-100V-BLDC-MDK-GEVK: 1kW, 60-100V Motor Development Board

Features

Applications

EEWORLD参考设计中心